Part 12112425

Purpose

Washer pump & drive belt kit—replaces both belts to ensure reliable spinning and drainage

Details

This OEM belt kit includes two essential V-shaped rubber belts: one drive belt (approx. ½″ wide × 42½″ long) and one pump belt. The drive belt loops around the motor pulley and splutch to spin the basket, while the pump belt powers the water pump for draining. Weak or broken belts commonly cause the washer to fill but not spin or drain, or result in error codes. Replacing both belts restores proper operation.

Compatible Models

Primarily used in **commercial Maytag washers**, especially models A15CA, A15CM, A15CT, A16CA, A17CA, A21CA, and similar series. Also applies to compatible top-load washers with dual V-belt systems—always verify compatibility using your washer model’s parts diagram.

Replaces

Replaces earlier belt numbers such as 22002570, 22002571, 211125, and 211124. Also can be found under variants like 12112425VP, W10175481, WP211125, and AP4011179. Check your model’s documentation for confirmation.

Highlights

• OEM belt set—ensures accurate fit and tested durability
• Application: drives tub spinning and drain pump operation
• Purpose: restores agitation, spin, and drainage when belts wear or fail
• Includes both drive belt (~½" × 42½") and pump belt—V-shaped for ideal traction
• Installation difficulty: Moderate—requires accessing the bottom or back of the washer to remove and loop the belts correctly; replacement guides available

Safety Note

Always disconnect power before servicing. Ensure both new belts are properly seated with correct tension before running a test cycle to confirm proper rotation and drainage.